Electrical System
36 24 690 07 Rev. HKohlerEngines.com
Fixed Ignition System
This system uses a capacitive discharge (CD) coil. Ignition timing and spark remains constant regardless of engine
speed. Timing of spark is controlled by location of ywheel magnet group as referenced to engine TDC. A typical xed
ignition system consists of:
● 1 magnet assembly which is permanently afxed to ywheel.
● 2 electronic capacitive-discharge ignition modules which mount on engine crankcase.
● 1 kill switch (or key switch) which grounds modules to stop engine.
● 2 spark plugs.
A Spark Plug(s) B Oil Pressure Switch C Oil Sentry
TM
(Green) D White Kill
E
Flywheel Stator
Assembly
F Ignition Module G
Non-Smart Spark
TM
Ignition
H
Rectier-Regulator
Connector
I Rectier-Regulator J
Oil Sentry
TM
Kill
(Green)
K Violet B+ L
Solenoid Shift Starter
Assembly
M Starter Solenoid Tang N Starter Solenoid Stud O Fuse P Blue
Q
Alternate Ignition Kill
(–)
R White S Accessory Terminal (+) T Yellow
U Ignition Kill V Red W Carburetor X Carburetor Solenoid
Y Black (Ground) Z Intake Manifold Screw AA Black AB
Oil Sentry
TM
Panel
Light/Remote Light
AC Oil Sentry
™
Light AD Connector AE Magneto AF Key Switch
AG Accessory AH Battery AI Starter AJ Ground
AK Key Switch Ground AL Rectier AM Blue/Red AN Battery Positive
AO Battery Negative