Kohler Decision-Makerr 8000 User Manual

32 TT-1625 7/17
The Menu List Summary indicates the various displays
within the SiteTecht software screens. Some displays
are read only while other fields require user input to set
up the RSA III. See Figure 54.
The User-Defined Settings (Figure 55) indicate the
ranges and default values for each selection. Value
entries outside the setting range are not accepted by the
firmware. Use the table to record user-defined settings
during the setup. The RSA III default settings and
ranges provide guidelines. Non-adjustable user-
defined settings are factory-set or firmware controlled.
The SiteTecht software has four fields of information
(Identity, Modbusr, Product Connections, and Product
Connection Inputs). The following information provides
a summary of the purpose of the four fields.
D Connected GenSet
d Product
d Address
d Timeout
D Connected ATS
d Connected
d Product
d Address
d Timeout
D Connected Annunciator 1
d Product
d Address
d Timeout
D Connected Annunciator 2
d Product
d Address
d Timeout
D Connected Annunciator 3
d Product
d Address
d Timeout
D Connected Annunciator 4
d Product
d Address
d Timeout
D Connected Annunciator 5
d Product
d Address
d Timeout
Identity
(Read only)
Modbus
(Read/Write)
D Vendor
D Product
D Firmware Version
D Modbus Baud Rate
D Is Modbus Master?
D Modbus Slave Address
D Modbus Timeout Factor
D Received Modbus *
Message Count *
D Modbus Error Count *
* Read only
Product Connections
(Read/Write)
D EPS Supplying Load
Indicator
D Digital Input 1
d Source
d Event Level
D Digital Input 2
d Source
d Event Level
D Digital Input 3
d Source
d Event Level
D Digital Input 4
d Source
d Event Level
D Digital Input 5
d Source
d Event Level
Product Connection
Inputs (Read/Write)
Figure 54 Menu List Summary

Kohler Decision-Makerr 8000 Specifications

General

Brand	Kohler
Model	Decision-Makerr 8000
Category	Controller
Language	English