6. Install the Supplies
CAUTION: Risk of restricted waterflow and product damage.
Use extreme care when bending the supply hoses to avoid
kinking and twisting. Hoses must not be taut after installation.
NOTE: If the sink installation requires that you coil the supply hoses
to obtain a good connection, maintain an inside coil diameter of at
least 3″ (7.6 cm).
Carefully position the hot and cold supplies so they will not
interfere with the other hoses.
Connect the supply hoses to the supply stops. Left is hot, right is
cold.
Tighten all connections.
7. Installation Checkout
Remove the aerator from the end of the spout by turning it
counterclockwise.
Turn on the main water supply.
Open the faucet handle to the ON position.
Flush hot then cold water through the faucet for about one
minute.
Push the faucet handle down to the OFF position.
Reattach the aerator by turning it clockwise.
3" (7.6 cm)
or Larger
Cold
Cold
Hot
Aerator
1036178-2-F 8 Kohler Co.
To Next Page
Loading...
Need help?
General
