3. Connect the Spray Hose
NOTE: To prevent kinking damage to the spray hose, the weight
must be installed onto the spray hose to act as a pull stop.
Slide the weight up 9″ (22.9 cm) from the unattached end of the
spray hose. If necessary, the weight may be moved up or down at
this time to adjust the pullout length of the spray hose.
Carefully tighten the weight screws on the weight at the desired
location. Do not overtighten.
Reconnect the unattached end of the spray hose to the hose
connector.
Spray Hose
Supply Hose
Valve Outlet Hose
Hose Guide
Weight
Spray Hose
9" (22.9 cm)
1004614-2-E 6 Kohler Co.