Kohler Touchless Flush User Manual

Kohler Co. 5 1322838-GL2-A
2. Check Operation
3. Complete the Installation
 Open the ll valve again, waiting for water to ll the tank. Check for leaks.
 Flush the toilet repeatedly using the sensing system. Check whether the
touchless full-ush and half-ush sensor can open the drain valve for
ushing normally. Sensitive range of the sensors: within 6 cm above the
sensing area of the tank.
 Press the manual buon to check
whether it can open the drain valve
for ushing normally.
NOTICE: If you are unable to activate the sensor immediately after installing
the tank lid, wait a minimum of 5 minutes for the sensor to be calibrated.
 Hold your hand within approximately 6 cm above the sensor.
 The toilet will ush.
 Consult the troubleshooting chart for operation or performance issues.
Operational Skills and Information
IMPORTANT: After the last ush, wait at least 10 seconds before aempting to
activate the sensor again. Please hold your hand within 6 cm above the sensor
for 1-2 seconds to conrm proper operation.
NOTE: If you are unable to activate the sensor immediately after installing the
baeries, wait a minimum of 5 minutes for the sensor to be calibrated.
 In order to prevent accidental ushing, the touchless haf-ush is suspended
for 10 seconds after use, while the touchless full-ush is suspended for
20 seconds after use.
 Hold your hand over the sensor for 1-2 seconds to activate the sensor.
 When the baeries are low, the unit will beep 3 times when activated, which
indicates that it’s time to replace the baeries.
NOTE: When the baeries run out and the ush can not be activated normally,
you can use the manual buon to ush.
Press
Manual
Button
Full-Flush
Sensor
Half-Flush
Sensor

Kohler Touchless Flush Specifications

General

Brand	Kohler
Model	Touchless Flush
Category	Toilets
Language	English