Kohler Touchless Flush User Manual

1322838-GL2-A 6 Kohler Co.
Symptoms Recommended Action
1. The toilet is blocked. A. Turn o the water supply. Clear the blockage using
a plunger. Consult the toilet troubleshooting for
further information.
2. Nothing happens
when I try to
activate the sensor.
A. Conrm the baeries are correctly installed.
B. Conrm the baeries have a charge.
C. Check whether the signal cables of the sensor and
the air pump box have come loose.
3. After the sensor
is activated, I hear
a beep, but the toilet
does not ush.
A. Does the baery box hanging on the rear of the
tank press on the wire rope of the drain valve?
If so, relocate the box.
B. Check whether the air tube connecting the ush
actuator and the air bump box has come loose.
4. The toilet ushes,
but the ush is weak.
A. Check whether the baeries are low.
B. Consult the toilet troubleshooting.
5. The sensor is not
sensitive enough.
A. Conrm that your hand is within 6 cm above the
sensor.
6. The toilet ushes
when I am siing
on it.
A. Are you leaning back and bumping the tank lid?
Moving the tank lid may cause the toilet to ush.
7. The toilet ushes
when opening the
seat cover.
A. Does the seat or lid strike the tank lid when they
are opened? Moving the tank lid may cause the
toilet to ush.
B. Is your hand within 60 mm above the sensor when
the toilet cover is open? When your hand is within
6 cm above the sensor, the ush will be activated.
8. After the manual
buon is pressed,
the ush is weak
or does not ush.
A. Is the buon pressed quickly and until fully
depressed?
Troubleshooting Guide
CAUTION: Risk of product damage. If the toilet is plugged, turn o
the water supply before aempting to unplug it. The sensor can be
inadvertently activated when dredging the toilet, which may result in
an overow.

Kohler Touchless Flush Specifications

General

Brand	Kohler
Model	Touchless Flush
Category	Toilets
Language	English