To Next Page

To Previous Page

650T/650R - Connecting the 650T/650R

5 Connecting the 650T/650R

You can use the 650T DVI-Coax Transmitter and the 650R Coax-DVI Receiver to

configure an DVI-to-Coax Transmitter and Receiver system (see Figure 3).

Always switch off the power to each device before connecting it to your

650T/650R. After connecting your 650T/650R, connect its power and

then switch on the power to each device.

To connect the DVI-to-Coax Transmitter and Receiver system as shown in the

example in Figure 3, do the following:

1. Connect an DVI source, for example, the DVI output from a Blu-ray DVD

player, to the 650T DVI IN connector.

2. Connect the 650R DVI OUT connector to the DVI acceptor, for example, a

projector.

3. If using a 4-plug coax cable or 4 coax cables:

 Connect the 650T red, green, blue, and clock BNC connectors to the

650R red, green, blue and, clock BNC connectors

 Connect 12V DC power supplies to both the 650T and the 650R (not

shown in Figure 3). The remote power and IR remote control functions

are not available

4. If using a 5-plug coax cable or 5 coax cables:

 Connect the 650T red, green, blue, clock, and power BNC connectors

to the 650R red, green, blue, clock, and power BNC connectors

 Connect one 12V DC power supply to either the 650T or the 650R (not

shown in Figure 3). Power and the IR remote control function are

transmitted over the power coax connection to the second device

Note: All coax cables must be the same length. There can be no more than 6

inches (15cm) difference in length between any of the cables.

5. Connect the power supply(s) to the mains electricity.

After all connections are made and the units are powered ON, the system

operates.

Kramer 650T User Manual

Questions and Answers: