12
Cordless Grass Trimmer
KG160E
KG160E.X
COMPONENT LIST
1. LOCK-OFF BUTTON
2. SWITCH TRIGGER
3. ECO BUTTON
4. HOOK
5. AUXILIARY HANDLE
6. LOCKING KNOB
7. SHAFT
8. SAFETY GUARD
9. LINE CUTTER
10. TRIMMER HEAD (BUMP HEAD)
11. SPOOL CAP
12. SPOOL
13. EYELET
14. CAP RELEASE LATCH
15. SHOULDER STRAP
Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type Designation: KG160E KG160E.X
(1-designation of machinery, representative of
Cordless Grass Trimmer)
KG160E KG160E.X *
Voltage
60 V
MAX **
No load speed
6000 /min
Cutting Diameter
38 cm
Line Diameter
Recommended 2.4mm twist line
Line length Recommended 4m
(Dual-Exit)
Machine Weight
(bare tool)
3.0 kg
* X=1-999, A-Z, M1-M9 there are only used for different
customers, there are no safe relevant changes between
these models.
** Voltage measured without workload. Initial battery
voltage reaches maximum of 60 volts. Nominal voltage
is 54 volts.
SUGGESTED BATTERIES
AND CHARGERS
Category Type Capacity
60V Battery
KA3000 2.0 Ah
KA3002 4.0 Ah
60V Charger KA3714
5.0 A
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure L
pA
=74 dB(A)
K
pA
0.8 dB(A)
A weighted sound power L
wA
= 94.8 dB(A)
K
wA
0.8 dB(A)
Wear ear protection
VIBRATION INFORMATION
Typical weighted vibration a
h
=5.326 m/s
2
Uncertainty K = 1.5 m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be used in
a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
To Next Page
Loading...
Need help?
General
