"
CLEANING
Before cleaning, turn "Off" unplug, and allow machine to cool
down.
The filter holder, filter basket and the overflow grid can be put
in the dishwasher. Be sure to place all parts in the upper rack
away from the heating/drying element.
The machine can be cleaned with a damp cloth. Never immerse
the body of your "IL Futuro, Jr." in water or any other liquid.
Clean the filter ring with a damp cloth and remove ground cof-
fee. If there is water left in the boiler container, let the machine
cool down, remove all loose parts and empty through the top
opening.
Cleaning The Steam Nozzle
Clean the steam nozzle each time after you have immersed
it in the milk, otherwise the inside of the nozzle can become
clogged with milk particles. If this does occur, unscrew the
nozzle tip (see figure 12) and use a sewing needle to remove
milk particles. Rinse under faucet to flush out any debrec.
Replace nozzle tip and screw on tightly.
Cleaning The Perfect Froth Attachment
For a thorough cleaning of the "Perfect Froth" attachment
remove part C (see figure 11).All parts should be rinsed in
warm water. Ifthe small suction opening in part A is clogged it
can be opened with a fine, sewing needle.
CAUTlON
DO NOTtry to open or disassemble the main body of the machine.
DECALCIFYING
Under normal conditions you do not need to decalcify your "IL Futuro, Jr.". However, in areas where
there is hard water or if used very frequently we recommend decalcifying. If you can see white
deposits in the boiler container, this is a good indication that your machine should be decalcified.
Decalcifier is widely available or can be purchased from the KRUPS Consumer Department.
How To Decalcify
. Remove stainless steel water screen and gasket from the machine (see figure 13)by using a
Phillips screwdriver.
. Insert the filter holder without the filter basket into the machine.
. Place a cup underneath the filter holder. Turn the machine "On" so that the solution can pass
through the water heating system into the cup.
. Repeat the above process using clean, cold water to remove all the remaining solution in the
machine. If necessary clean twice. Allow machine to cool down between each time when
cleansing.
11
To Next Page
Loading...
Need help?
General
