Put the water tank
back in place. The
light turns off and the
'calc' light stops blin-
king.
1 - Descaling cycle
The 'calc' light stops blinking.
The descaling cycle starts and is carried out automatically. The pump occasionally sucks up water which comes out of the
coffee nozzles and then the steam nozzle. This operation lasts approximately 10 minutes.
10
SCALE REMOVAL PROGRAM – TOTAL DURATION: ABOUT 22 MINUTES.
The quantity of scale deposited depends on the hardness of the water used. The appliance will automatically
warn you by the ‘calc’ light coming on when you need to proceed with scale removal.
This program is only accessible when the machine requests it.
C
aution! To benefit from the guarantee conditions, it is essential to perform the appliance scale removal
c
ycle when informed to do so. Be sure to follow the procedure closely step by step.
Y
ou can continue to use the appliance when the light is on, but you are advised to perform the program as soon
a
s possible.
Press the ‘Service’
key to start up the
scale removal
program. The ‘calc’
and lights will
flash.
Place a receptacle with
a minimum water
capacity of 0.6 l under
the coffee outlets and
under the steam nozzle.
Remove and clean the
drip tray.
Empty the tank and fill
it with lukewarm water
up to the ‘calc’ marking.
Dissolve a sachet of
Krups scale remover
F054 (40 g).
Press the 'Service' but-
ton after having carried
out all of these opera-
tions.
Only use KRUPS scale removal products, citric acid or tartaric acid. You can obtain scale remover from KRUPS
Service Centres. In no event must you use conventional starchy sulphonic acid or other products containing that acid.
The manufacturer may not be held responsible for damage to the appliance through use of other products.
±
±
1
1
0
0
m
m
n
n
F054
Make certain to protect your work surface during cleaning and scale removal cycles, especially if they
are made of marble, stone or wood.
I
f your appliances fitted with our Claris - Aqua Filter System F088 cartridge, please remove the cartridge
d
uring the descaling operation.
When the cycle has
completed, the ‘water
tank’ and ‘calc’ lights
blink.
ENGLISH
To Next Page
Loading...
Need help?
General
