Krups ESPRESSERIA AUTOMATIC Manual

5
It is preferable to rinse the 2 circuits out at least once after the machine has not been used for several days.
Each time you plug your machine in, it will carry out an initialisation cycle.
P
ull out and fill the
w
ater tank.
Put it back in place by
pressing firmly and
close the lid again.
Open the coffee bean
container lid. Add the
coffee beans (250 g
maximum).
Close the coffee bean
container lid again.
Check that the coffee beans do not contain any foreign particles such as grit, as any damage caused by the presence of
foreign particles will negate the warranty.
Do not put water into the coffee bean container.
Remember to fit the drip tray to avoid waste water flowing onto the work surface and staining it or scalding you.
Check that your water tank is clean.
Turn the appliance on by pressing the
button. The light will flash during the
pre-heating and initialisation cycle.
Rinsing out the coffee circuit:
Place a recipient of at least 0.5 L under the
coffee and steam nozzles. Press the 'Service'
button quickly to start a coffee circuit rinsing
cycle, which will automatically stop after
around 40 mL.
You can choose the strength of your coffee by setting the coffee bean grinding fineness.
The finer the grinding setting, the stronger and creamier the coffee should be. Set the desired fineness for grinding by tur-
ning the ‘Grinding fineness setting’ knob.
CHANGE THE SETTING DURING GRINDING.
NEVER FORCE THE GRINDING FINENESS SETTING BUTTON
It is recommended that you do not use oily, caramelised or flavoured coffee beans for this machine. These kinds of beans
may damage the machine.
NEVER PUT GROUND COFFEE IN THE COFFEE CONTAINER.
Turn to the left
for finer grind.
Turn to the right
for coarser
grind.
Do not fill the water tank with hot water, mineral water, milk or any other liquid. If you turn on the appliance when
the water tank is not in place or not correctly filled (under the “min.” level,), the “fill water tank” light will come on and
making an espresso or a cup of coffee will be made impossible.
PREPARING THE APPLIANCE
Rinsing out the steam circuit:
Press the ’Service’ button for 3
seconds to start a steam circuit rin-
sing cycle, which will automatically
stop after around 300 mL.
PREPARING THE GRINDER
RINSING OF CIRCUITS

Krups ESPRESSERIA AUTOMATIC Specifications

General

Brand	Krups
Model	ESPRESSERIA AUTOMATIC
Category	Coffee Maker
Language	English