DURING THE BREW CYCLE STEAM RISES FROM THE
TOP OF THE MACHINE. BE CAREFUL TO KEEP HANDS
AWAY FROM THIS AREA UNTIL AFTER THE BREW
CYCLE IS COMPLETED !
Au t o - O f f f u n c t i o n :
n
The heating plate keeps the jug at the right temperature for 30 minutes,
and then the machine turns off automatically. This is for safety and
convenience. The time period before the automatic shutdown can be set
at 30 minutes, 2 or 3 hours. See page 21 – Programming the unit.
n
For best results brew only as much coffee as you will drink within 30-60
minutes.
Pa u s e a n d S e r v e f e a t u r e :
n
You can remove the jug during the brew cycles to pour an early cup. Keep
in mind that this will change the taste you would normally get from a full
pot in a complete cycle.
Be sure to replace the jug quickly (less than 20 seconds) to avoid
overflow during the brew cycle.
For models with thermal pot : to ensure maximum heat retention, rinse
the thermal pot with hot water before use, and close the lid by turning
clockwise.
WARNING :
Hot water continues to drip in the filter holder (h) when
the jug (f) is removed. The overflow of coffee and hot
water could cause burns.
Do not exceed the maximum capacity of the water tank as
shown by the water level indicator (g).
Place the ground coffee into the paper filter or directly
into a permanent filter.
Note : Pay attention to max level indicated on permanent filter.
After use, discard the grounds, and rinse the filter holder under
running water.
20
KR_CAFETIERE_DAHLSTROM_ELECTRO_NC00125646_Mise en page 1 08/07/14 09:57 Page20
To Next Page
Loading...
Need help?
General
