27
Supressing the
«5000 espressos or coffees» signal
When the appliance has prepared 5000 espresso coffees, the «on/off», «fill water tank»,
«empty the collector», «clean» and «descale» indicators flash for about 8 seconds
when the appliance is started.
After 5000 espresso coffees we advise you to contact the KRUPS authorised service dealer
to have the appliance inspected.
If you do not wish to have this inspection performed, you can cancel the flashing of these
indicators:
•With the appliance off, but plugged in, press the control for about 3 seconds.The 5 red
indicator lights will then flash for 3 seconds and the appliance will go off.
Transporting the appliance
•Retain and use the original packaging to transport the appliance.
•Before transporting the appliance, always purge all the water from the heating circuit.
Accessories
Yo u can obtain these accessories from the authorised KRUPS service dealer - 0121 200 2740
Disposal of the packaging materials and
of the appliance
The packaging consists solely of materials which are not hazardous to the environment,
and which can be disposed of in accordance with the recycling provisions in force.
To dispose of the appliance, you can obtain information from the appropriate department
of your local authority.
KRUPS
Problems, causes, solutions
Problems Causes Solutions
The espresso coffee is not The cups are too cold. Preheat the cups with hot water.
hot enough.
Only part of the espresso coffee There is not enough ground coffee. Use the correct quantity of
is running through. ground coffee.
The coffee bean compartment is Add coffee beans.
empty.
There is not enough froth on The milk is not suitable:either out Change the milk. Use only very
the milk. of date, wrong fat content, or fresh, cold milk.
too hot.
The nozzle is blocked. Clean the steam nozzle.
The air aspiration hole of the Clean the frothing aid.
frothing aid is blocked.
The grinder makes a lot of noise. Presence of foreign bodies in If after making several espressos,
the grinder. the grinder makes even more
noise, take the appliance to the
KRUPS authorised service dealer.
Continue to use the appliance but
only with ready-ground coffee.
The tray and the coffee collector Power cut or plug inserted Plug in at the mains and put in
cannot be put back in place. incorrectly. place the tray and the support for
the coffee collector only.Turn on
the appliance and put the coffee
collector in place.
The cleaning programme refuses Steam has just been produced. Fill the heating circuit – Page 11.
to start.
If you have any problems or queries, call our helpline:-
0845 330 6460 - UK or (01) 4751947 - Ireland
Website: www.perfect-coffee.com
Cleaning tablets Ref. F 055 0010
Descaling Kit Ref. F 054 0010
• 2 sachets of descaler
• 1 «water hardness» test stick
To Next Page
Loading...
Need help?
General
