English
6
n Turn the knob to "0" position.
In this manner you can be sure that water is circulating well through the filter cartridge.
IMPORTANT:
This installation procedure must be carried out every time the cartridge is
replaced.
The Claris cartridge needs to be replaced every 2 to 3 months if it is used daily.
C. RINSING YOUR APPLIANCE (to be done on first use and after each cleaning /
descaling operation)
- RINSING OUT THE ESPRESSO CIRCUIT
n Turn on the appliance and fill the water tank (Fig. 1, 2, 3 & 4).
n Insert the filter holder (without ground coffee) in the appliance (Fig. 7).
n Place a container of sufficient volume under the filter holder.
n As soon as the appliance reaches the right temperature, the LED glows steadily and the
pictograms and are displayed.
n Press the button and let the water run out into the container (fig.9).
n Repeat this operation 5 times.
n If necessary, stop the operation by pressing the button to empty the container and then resume
the operation (fig.9).
n Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and
turn it to the left (fig.10).
-
RINSING OUT THE STEAM CIRCUIT.
Before using the steam function for the first time, the steam circuit should be cleaned.
n Fill the water tank. Make sure that the steam function dial is in O position.
n Turn the appliance on by pressing the button.
n Place a container underneath the steam nozzle.
n When the light indicator glows, press the button: the light indicator and the pictogram
on the display will begin to blink.
n When they have stopped blinking, turn the dial to the position and allow the water to flow until
steam is generated.
n Keep the steam production going for at least 30 seconds.
Before making an espresso, make sure the steam knob on the left of the appliance is in 0
position.
In order to release all the aromas of the coffee and ensure your complete satisfaction, this machine pre-
brews each coffee. The pump works for 3 seconds, stops the following 3 seconds and then the cycle
continues until the end of the preparation.
PREHEATING THE ACCESSORIES
n For best results, we recommend that you first pre-heat the accessories (filter holder and cups)
without ground coffee. To do this:
n Fill the water tank and turn on the appliance (Fig. 1, 2, 3 and 4).
n Put the filter holder in place and place the cups underneath.
n As soon as the appliance reaches the right temperature, the LED glows steadily and the
pictograms and are displayed.
n Then press the or button (fig.8 ou 9).
n Once the cup(s) are filled with hot water, remove them.
n Unlock the filter holder: press the "OPEN" button by turning the filter holder to the left and remove
it from the appliance.
Espresso
2 . MAKING AN ESPRESSO
Espresso
KR_XP2280_NAFTA_NC00026071-01 17/11/11 17:55 Page6
To Next Page
Loading...
Need help?
General
