KTM 350 EXC-F 2023 User Manual

SERVICE WORK ON THE ENGINE 18
131
K00572-10
–
Pull oil filter
6
out of the oil filter housing.
Lock ring plier (51012011000)
– Allow the engine oil to drain completely.
– Thoroughly clean the parts and the sealing surface.
K00573-10
–
Lay the motorcycle on its right side and fill the oil filter hous-
ing approx. ⅓ full with engine oil.
– Place the oil filter into the oil filter housing.
– Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
7
.
– Mount and tighten the screws.
Guideline
Screw, oil filter cover M6 10 Nm (7.4 lbf ft)
– Stand the motorcycle upright.
401955-12
–
Remove filler plug
8
from the clutch cover together with the
O-ring, and fill up with engine oil.
Engine oil 1.0 l (1.1 qt.) Engine oil
(SAE 10W/50)
( p. 147)
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
– Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation
when running the engine.
– Use effective exhaust extraction when starting or
running the engine in an enclosed space.
– Start the engine and check it for leaks.
Finishing work
– Check the engine oil level. ( p. 129)

KTM 350 EXC-F 2023 Specifications

General

Displacement	349.7 cm³
Bore x Stroke	88 mm x 57.5 mm
Starter	Electric starter
Transmission	6-speed
Cooling	Liquid cooled
Clutch	Wet, DDS multi-disc clutch, Brembo hydraulics
Front Suspension	WP XPLOR-USD, Ø 48 mm
Seat Height	960 mm
Engine Type	Single Cylinder, 4-Stroke
Frame	Central double-cradle type 25CrMo4 steel
Rear Suspension	WP XPLOR shock absorber
Front Brake	Disc brake, 260 mm
Rear Brake	Disc brake, 220 mm
ABS	Not equipped
Fuel System	Keihin EFI, throttle body 42 mm
Fuel Tank Capacity	9.0 liters