SERVICE SCHEDULE 10
49
every 2,250 km (1,395 mi)
every 1,500 km (930 mi)
every 750 km (465 mi)
after 50 km (31 mi)
Check the antifreeze and coolant level. ( p. 119) ○ ● ● ●
Check the cables for damage and for routing without kinks. ● ● ●
Check that the throttle cables are undamaged, routed without kinks, and set correctly. ○ ● ● ●
Clean the air filter and air filter box. ( p. 74) ● ● ●
Change the glass fiber yarn filling of the main silencer. ( p. 77) ●
Service the fork. ●
Perform the shock absorber service. ●
Check the tightness of the easily accessible, safety-relevant screws and nuts. ○ ● ● ●
Check the headlight setting. ( p. 116) ○ ● ● ●
Change the fuel screen. ( p. 128) ○ ● ● ●
Check the fuel pressure. ● ● ●
Check idle. ○ ● ● ●
Check that the radiator fan is functioning properly. ○ ● ● ●
Check the inlet membrane. ●
Final check: Check the vehicle is roadworthy and take a test ride. ○ ● ● ●
Read out the error memory after the test ride using the KTM diagnostics tool. ○ ● ● ●
Make a service entry in KTM Dealer.net. ○ ● ● ●
○ One-time interval
● Periodic interval
10.3 Recommended work
every 48 months
every 12 months
every 6,750 km (4,185 mi)
after 1,000 km (620 mi)
after 500 km (310 mi)
Change the front brake fluid. ● ●
Change the rear brake fluid. ● ●
Change the hydraulic clutch fluid. ( p. 89) ● ●
Lubricate the steering head bearing. ( p. 68) ● ●
Clean the spark arrestor. ( p. 75) ● ●
Service the fork. ○
Perform the shock absorber service. ○
Change the fuel filter. ●
Change the coolant. ( p. 122) ●
Perform engine service including removing and installing the engine. (Change the spark
plug and spark plug connector. Change the piston. Check/measure the cylinder. Check
the cylinder head. Change the valves, valve springs, and valve spring seats. Check the
camshaft and cam lever. Change the connecting rod, conrod bearing and crank pin.
Change the radial shaft seal rings of the water pump. Check the transmission and the
shift mechanism. Check the oil pressure control valve. Change the suction pump. Check
the force pump and lubrication system. Check the timing assembly. Change the timing
chain. Change all engine bearings. Change the freewheel.)
●
To Next Page
Need help?
General
