To Next Page

To Previous Page

SETUP 2

2.1 Transport mode

H02712-01

This vehicle was blocked for transport in the software.

To operate the vehicle, the vehicle electronics must be enabled.

This process is conducted during initial setup in KTM Dealer.net.

Enabling ensures that the initial setup in KTM Dealer.net is docu-

mented.

Enabling can be performed either temporarily, e.g. for a test ride,

or permanently for vehicle handover.

Info

Make sure that the vehicle is permanently enabled before

handing it over to the customer.

2.2 Unpacking and setting up the vehicle

E00851-10

Package 2

– Remove the box and the plastic packaging.

Info

To avoid damaging the motorcycle during the setup,

leave the protective film on the vehicle until you

have finished.

– Remove the separate enclosure and unpack it. Check

that the scope of supply is complete on the basis of the

enclosed packing list.

– Remove cable ties on rear wheel, take off front wheel and

fender.

– Have a lift stand available.

Lift stand (78129955100)

– Carefully loosen and remove the tension belt of the footrest

mount.

Info

An assistant prevents the motorcycle from falling

over.

402050-01

– Together with an assistant, take the vehicle off the pallet.

– Position the vehicle on a lift stand.

– Check the vehicle for transport damage.

Other manuals for KTM 450 SX-F 2019

Questions and Answers:

Need help?

Do you have a question about the KTM 450 SX-F 2019 and is the answer not in the manual?

General