13 WHEELS, TIRES 70
101961-10
(SX‑F Factory Edition)
–
Align the brake disc guard so that gaps
A
and
B
are the same size.
S00153-11
–
Mount and tighten screw
2
.
Guideline
(SX‑F EU, SX‑F USA, XC‑F)
Screw, front wheel spindle M24x1.5 45 Nm
(33.2 lbf ft)
(SX‑F Factory Edition)
Screw, front wheel spindle M20x1.5 35 Nm
(25.8 lbf ft)
– Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
– Remove the motorcycle from the lift stand. ( p. 36)
– Pull the front brake and compress the fork powerfully a few times.
The fork legs straighten.
–
Tighten screws
3
.
Guideline
Screw, fork stub M8 15 Nm
(11.1 lbf ft)
13.3 Removing the rear wheel x
Preparatory work
– Raise the motorcycle with the lift stand. ( p. 36)
C00447-10
Main work
– Press the brake caliper onto the brake disc by hand in order to push back the brake
piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove nut
1
.
–
Remove chain adjuster
2
. Withdraw wheel spindle
3
only enough to allow the
rear wheel to be pushed forward.
– Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
Info
Protect the components against damage by covering them.
– Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swing arm.
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
To Next Page
Loading...
Need help?
General
