MAINTENANCE ON CHASSIS AND ENGINE 69
Warning
Danger of accidents Do not make any radical changes to the adjustment of the shock absorbers.
– Only make adjustments within the recommended range.
Info
The rebound damping setting has an impact on the compression of the shock absorber.
100028-10
– Turn the adjusting screw clockwise until it stops.
– Turn back counterclockwise by the number of clicks corresponding to the shock
absorber type.
Guideline
Rebound damping
Standard 20 clicks
Maximum deviation from standard
value
−5… 5 clicks
Tip
Experience has shown that settings outside of this range are detrimental to vehi-
cle handling. When changing the chassis settings, always start with the standard
setting.
Info
Turn clockwise to increase damping, turn counterclockwise to reduce suspension
damping.
The left and right shock absorbers should have the same settings.
To Next Page
Loading...
Need help?
General
