11 SERVICE WORK ON THE CHASSIS 82
101989-10
Main work
–
Loosen nut
.
–
Loosen nuts
.
–
Adjust the chain tension by turning adjusting screws
on the left and right.
Guideline
Chain tension 5 mm (0.2 in)
Turn the left and right adjusting screws
so that the markings on the left and right
chain adjusters
are in the same position relative to the reference marks
. The
rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even. Repeat this measurement at different chain posi-
tions.
–
Tighten nuts
.
–
Make sure that the chain adjusters
are installed correctly on adjusting screws
.
–
Tighten nut
.
Guideline
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft)
11.18 Checking the chain, rear sprocket, engine sprocket, and chain guide
Preparatory work
– Raise the motorcycle with the rear wheel stand. ( p. 70)
To Next Page
Loading...
Need help?
General
