PREPARING FOR USE 7
23
Always make sure the lithium-ion battery is charged to that there
is enough power to spare for starting at low temperatures.
After 6 unsuccessful starting attempts, do not try again, and check
the vehicle for other malfunctions instead.
7.4 Preparing the vehicle for difficult operating conditions
Info
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can result in
significantly increased wear of components, such as the drive train, brake system, or suspension compo-
nents. For this reason, it may be necessary to inspect or replace parts before the next scheduled service.
– Clean the air filter and air filter box. ( p. 65)
Info
Check the air filter approx. every 30 minutes.
– Prepare air filter box cover for securing. ( p. 67)
– Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
– Clean and dry the connector, or change it if necessary.
Difficult operating conditions are:
– Rides on dry sand. ( p. 23)
– Rides on wet sand. ( p. 24)
– Rides on wet and muddy circuits. ( p. 24)
– Rides at high temperatures or slow riding. ( p. 25)
– Riding at low temperatures and in snow. ( p. 25)
7.5 Preparing the vehicle for rides on dry sand
F03669-01
– Mount the air filter dust cover.
Air filter dust cover (A46006920000)
Info
Observe the fitting instructions for KTM PowerParts.
F03670-01
– Mount the air filter sand cover.
Air filter sand cover (A46006922000)
Info
Observe the fitting instructions for KTM PowerParts.
To Next Page
Loading...
Need help?
General
