BLOWING
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow
the instructions listed.
1. Verify that the power cord is disconnected from the outlet.
2. Make sure the container is empty before using as a blower.
Remove hose from the vacuum port.
3. Insert the large end of the hose into the blowing port on the back
side of the power head and secure in position. Fit the desired
extension wand and/or nozzle to the vacuum hose.
4. Verify that the switch is in the ‘O’ (OFF) position before plugging the
power cord into the outlet.
5. Insert the plug into the socket.
6. Before turning on the vac, rmly hold loose end of the hose. Turn the
motor on by ipping the switch to the ‘I’ (ON) position.
WARNING: ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH
ANSI Z87.1 (OR IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING: WEAR A DUST MASK IF BLOWING CREATES DUST THAT
MIGHT BE INHALED.
To Next Page
Loading...
Need help?
General
