PERIODIC SERVICE86
BChanging Engine oil
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely into
the oil pan.
All the used oil can be drained out easily when the
engine is still warm.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper line on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
BReplacing Transmission Oil Filter [HST]
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Place the oil pan underneath the transmission oil filter
and remove the filter.
Do not remove the hydraulic oil filter. Otherwise, the oil
comes out.
2. Put a film of clean transmission oil on the rubber seal
of the new filter.
3. Quickly tighten the filter until it contacts the mounting
surface, then, with a filter wrench, tighten it an
additional 1 turn only.
4. After the new filter has been replaced, fill the
transmission oil up to the upper limit on the dipstick.
Oil capacity with filter 4.0 L (4.2 U.S.qts.)
(1) Oil inlet
(2) Dipstick
(A) Oil level is acceptable within this range
(1) Drain plug (both sides)
(1) Transmission oil filter [HST]
To Next Page
Loading...
Need help?
General
