~
■
Checking
Intake Air Line
A CAUTION
To avoid personal injury:
• Be sure to stop the engine and remove the key
before checking intake air line.
1. Check to see that hoses and hose clamps are tight and
not damaged.
2. If hoses and clamps are found to be worn or damaged,
replace or repair them at once. ·
l'f lfr~"L!.f~.::.:.::.:==--------=---------------'
(1) Hose
· (2) Hose clamp
PERIODIC SERVICE 49
■
Adjusting
Toe-in
1. Park tractor on a firm, flat and level place.
2. Turn steering wheel so front wheels are in the straight
ahead position.
3. Lower the implement to the ground, lock the parking
brake, stop the engine and remove the key.
4. Measure distance between tire beads at front of tire at
hub height. _.
5. Measure distance between tire beads at rear of tiie :· · ·
hub height. '
6. Front distance should be 1 to 10mm (1/16 to 3/8 in.) -
less than rear dista_nce. If not, adjust tie rod length.
F-3197A
I·
®
I
\·
©
®
·I
(A) Wheel - to - wheel distance at rear
(B) Wheel- to - wheel distance at front
(C)~FRONT"
♦
Adjusting procedure
1. Loosen the lock nut and turn the tie rod to adjust the
rod length until the proper toe-in measurement is
obtained.
2. Retighten the lock nut.
(1) Lock nuts
(2) Tie-rod
0
0
0
0 0
To Next Page
Loading...
Need help?
General
