5. Place
the
position-control-lever
and the draft-
control-lever if equipped in the “FLOAT” position.
The “FLOAT” position is the lowest position of
position-control-lever and draft-control-lever.
(1) Position control lever
(2) Draft control lever (if equip-
ped)
(A) Down
6.
Set the hand-throttle-lever to about 1/2 way.
(1) Hand throttle lever
(2) Foot throttle
(A) Increase
(B)
Decrease
7. Insert the starter key into the key switch and turn it
“ON”.
(A) Off
(B) On
(C) Start
8. Check the Easy Checker
™
lamps.
(See Easy Checker
™
lamps on page 31
)
(1) Electrical charge indicator
(2) Parking brake indicator
(3) Engine oil pressure warning
indicator
(4)
Glow plug indicator
NOTE :
• Some of the
Easy Checker
™
lamps may light
up depending on the positions of the levers
and switches.
• Turn on the key switch, and some of the
indicators on the instrument panel stay on
about 1 second.
9. Fully depress the clutch pedal.
(1) Clutch pedal
10. Turn the starter key to the “STAR
T” position and
release it when the engine starts.
IMPORTANT :
• Because of the safety devices, the engine
will not start except the following
conditions:
– PTO-clutch-control-switch is placed in
the “OFF” position.
– Synchro-shuttle shift lever is placed in
the “NEUTRAL” position.
11. Check to see that all the lamps on the Easy
Checker
™
are “OFF”.
If the lamps on the Easy Checker
™
is still on,
immediately stop the engine and determine the
cause.
OPERATING THE ENGINE
To Next Page
Loading...
Need help?
General
