5. Place
the PTO-clutch-control-switch in the “OFF”
position.
(1) PTO clutch control switch (A) Push
(B) On (Engaged)
(C) Off (Disengaged)
6.
Place
the
position-control-lever
and the draft-
control-lever if equipped in the “FLOAT” position.
The “FLOAT” position is the lowest position of
position-control-lever and draft-control-lever.
(1) Position control lever
(2) Draft control lever (if equip-
ped)
(A) Down
7.
Set the hand-throttle-lever to about 1/2 way.
(1) Hand throttle lever
(2) Foot throttle
(A) Increase
(B) Decrease
8. Insert
the starter key into the key switch and turn it
“ON”
.
(A) Off
(B) On
(C) Start
9.
Check the Easy Checker
™
lamps.
(See Easy Checker
™
lamps on page 31
)
(1) Electrical charge indicator
(2) Parking brake indicator
(3) Engine oil pressure warning
indicator
(4)
Glow plug indicator
NOTE :
• Some of the
Easy Checker
™
lamps may light
up depending on the positions of the levers
and switches.
• Turn on the key switch, and some of the
indicators on the instrument panel stay on
about 1 second.
10. Turn the starter key to the “START” position and
release it when the engine starts.
IMPORTANT :
• Because of safety devices, the engine will
not start except the following conditions:
– PTO-clutch-control-switch is placed in
the “OFF” position.
– Speed-control-pedal is placed in the
“NEUTRAL” position.
OPERATING THE ENGINE
To Next Page
Loading...
Need help?
General
