(1) Dead battery
(2) Jumper cables
(3) Helper battery
1.
Bring
the helper vehicle with a battery of the same
voltage
as
the disabled tractor within easy cable
reach.
IMPORTANT :
• The helper vehicle must not touch the
disabled tractor.
2. Engage the parking brakes of both vehicles and put
the shift levers in the “NEUTRAL” position. Shut
both engines off.
3. Wear an eye protection and rubber gloves.
4. Attach the red clamp to the positive (red, (+) or
pos.) terminal of the dead battery, and clamp the
other end of the same cable to the positive (red, (+)
or pos.) terminal of the helper battery.
5. Clamp the other cable to the negative (black, (-) or
neg.) terminal of the helper battery.
6. Clamp the other end of the cable, which is clamped
to the negative terminal of the helper battery, to the
engine block or frame of the disabled tractor as far
from the dead battery as possible.
7. Start the helper vehicle and let its engine run for a
few moments. Start the disabled tractor.
8. Disconnect the jumper cables in the exact reverse
order of attachment.
See the steps in order of step 6., step 5., and step
4.
OPERATING THE ENGINE