Proper Riding Method
55
TPMS Learn Code Operation:
Applicable to owner and dealer service personnel.
Re-adjustment of TPMS is required when replacing a new
wireless tire pressure sensor and controller.
When performing code learning, keep the vicinity clear of
other vehicle or transmitter, to prevent miss-triggering.
Confirm that the electronic tire pressure detector has been
correctly installed, that the tire pressure meets the intended
pressure value and that the tires are correctly installed.
Learn Code Activation Procedure:
1. Press and hold the “MENU” button in the Right
handlebar switch when the Tire pressure indicator
symbol is indicated.
“MENU” button Tire pressure indicator symbol
2. Press the KEYLESS main switch to ON.
3. Wait until the image of tires appear and release the
“MENU” button.
4. TPMS is now entered into Code Learning Mode.
5. The front/rear tire symbol is flashing without the Tire
Pressure value disappeared, indicates it is under code-
learning state.
6. Flatten or refill the tire so that the change in tire
pressure is greater the 3 psi, then the sensor will be
activated within 1 min. Once there is a reading of the
tire pressure, the code-learning settings of a tire is
completed.
7. After the code-learning settings of a tire is completed, it
will automatically go to the next tire for code-learning.
8. The operator will also go the next tire and repeat the
above steps for code-learning settings.
9. If one wishes not to code-learn, press the “︿” button to
skip to the next round of code-learning. If code-learning
is not completed within 2 mins, it will exit the code-
learning mode.
10. After the code-learning settings, press the “︿ ”
button to leave exit, or press KEYLESS main switch
ON-OFF to restart.
To Next Page
Need help?
General
