MAINTENANCE
Reinstall the drain plug and tighten it to the
specified torque.
4.
Oil drain plug torque: 18 lb-ft (25 N-m)
Add oil to the engine per the amounts listed
below, and reinstall the oil filler/dipstick.
5.
Engine oil capacity: 0.85 qt (0.8 L)
NOTE: Amounts are after draining the oil
only.
Start the engine and let it idle for 2 - 3 minutes.
6.
Stop the engine and check the oil level on the
dipstick when the scooter is parked on the
center stand, on level ground.
7.
Adjust the oil level as required (so the level
reaches the upper mark on the dipstick).
Replace the dipstick and inspect for any leaks.
8.
CAUTION
Running the engine with insufficient oil pressure
can cause serious engine damage.
Remove the oil drain plug from the crankcase
to drain the oil.
3.
22
To Next Page
Need help?
General
