PUSHING AND TRANSPORTING THE SCOOTER
1. Please carefully read the safety information in
section 3 related to transportation first.
2. Pushing the scooter:
In order to push the scooter, you must place the scooter
in “freewheel” mode, which disengages the drive
motor.
The lever is located at the bottom right-hand side of the
scooter under the seat.
WARNING!
When the lever is pulled up in freewheel mode:
• The scooter must be on a flat surface.
• Do not sit on the scooter.
6.1 To push the scooter:
= Freewheel Mode:
(Motor is disengaged.)
1. Power off the scooter and
remove the key.
2. Pull the lever rightwards as
far as the stop (see diagram).
3. Push the scooter to your
desired location.
4. Pull the lever leftwards as far
as the stop (see diagram).
=Driving Mode(B):(Motor is engaged.)
1. Always switch the scooter off to push it.
2. Do not push the scooter too fast. If a pre-set
speed is exceeded while you are pushing the scooter,
the drive motor will switch on automatically and brake
the scooter.
17
To Next Page
Loading...
Need help?
General
