9.DRIVE AND DRIVEN PULLEYS
9-12
Check the movable driven face for wear or
damage.
Measure the movable driven face I.D.
Service Limit: 34.06 mm (1.3624 in)
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Drive the inner needle bearing out of the
driven pulley face.
Remove the snap ring and drive the outer
bearing out of the driven face.
Bearing Puller A120E00037
Apply grease to the outer bearing.
Drive a new outer bearing into the driven face
with the sealed end facing up.
Seat the snap ring in its groove.
Apply grease to the driven face bore areas.
Press a new needle bearing into the driven
face.
Oil Seal And Bearing Install A120E00014
Inner Needle Bearing
Outer Bearing
Discard the removed bearing and replace
with a new one.
＊
Discard the removed bearing and replace
with a new one.
＊
Snap Ring
Snap Ring
Outer Bearing
Inner Needle Bearing
Pack all bearing cavities with proper
grease.
Specified grease: Heat resistance 230°C
＊
To Next Page
Loading...
Need help?
General
