3. INSPECTION/ADJUSTMENT
3-20
HEADLIGHT BEAM
ADJUSTMENT (ON ROAD
ONLY)
Vertical adjustment:
Turn the ignition switch ON and start the
engine.
Turn on the headlight switch.
Adjust the headlight aim by turning the
headlight aim adjusting screw.
BRAKE PEDAL ADJUSTMENT
( ON ROAD ONLY)
The brake pedal free play should be
adjusted to 5~10 mm (0.2~0.4 in) at the
brake pedal pivot. If the free play is
incorrect, adjust as follows:
Adjust:
1. Keep front brake lever free play at 10~20
mm (0.4~0.8 in).
2. Loosen the locknuts. (R/L front lower
brake cables)
3. Turn the adjusting bolts until the front
lower brake cables is tensed.
4. Apply the front brake lever and check
front brake cam lever to make sure that
the brake does not drag after adjusting.
5. While remove the cable joint case cover
and applying the brake pedal, make sure
the left and right front lower cable
lengths (A and B) are equal. The cable
joint will become vertical.
6. Tighten the locknuts. (R/L front lower
brake cables)
Headligh
To Next Page
Loading...
Need help?
General
