2. FRAME COVERS/EXHAUST MUFFLER
2-6
INSTALLATION
Reverse the “FRONT FENDER
REMOVAL” procedures.
REAR FENDER REMOVAL
Remove the front fender. (See page 2-5)
Remove the battery. (See chapter 14)
Remove the starter relay and CDI unit.
Remove the ten screws attaching the rear
fender and foot boards at the right/left side.
Remove the two screws attaching the rear
fender at the rear.
Remove the three bolts attaching the rear
fender at the center and then remove the
rear fender.
After remove, be sure to tighten the fuel
filler cap.
＊
Starter Relay Ignition Uni
To Next Page
Loading...
Need help?
General
