4. LUBRICATION SYSTEM
4-17
OIL PUMP (50cc-2T)
REMOVAL
Disconnect the oil outlet tube from the oil
pump.
Disconnect the oil pump control cable from
the pump body.
Disconnect the oil inlet tube.
Remove the oil pump control cable plate
bolts.
Remove the oil pump from the crankcase.
OIL PUMP INSPECTION
Remove the oil pump and inspect the
following items:
• Weakened O-ring
• Damage to crankcase mating surface
• Damage to pump body
• Control lever operation
• Oil leaks through oil seals
• Worn or damaged pump pinion
Do not allow foreign matters to enter the
crankcase. Before removing the oil
pump, clean the oil pump and crankcase
surfaces.
＊
Do not disassemble the oil pump which
cannot be used after disassembly.
＊
O-ring
Gea
Oil Inlet Tube
Oil Pump Control Cable
Oil Pump Control Cable
Oil Outlet Tube
Before disconnecting the oil line, clip
the oil line to avoid oil flowing out and
then plug the oil line after it is
disconnected.
＊
Bolts
Oil Pump
Oil Pump Control
Cable Plate
To Next Page
Loading...
Need help?
General
