Examples:
8h: Version 8 will always be used. If the data cannot be accommodated, an error
message will be printed instead of the symbol.
11,30h: The software selects the smallest possible version to accommodate the data,
but does not use a version lower than 11 or a version higher than 30. If the data
cannot be accommodated in version 30, an error message will be printed instead of
the symbol.
1,15h: The software selects the smallest possible version to accommodate the data,
but does not use a version higher than 15. If the data cannot be accommodated in
version 15, an error message will be printed instead of the symbol.
s parameter: character set
Possible values:
0 = Automatic selection between Kanji and binary encoding
1 = Numeric: Digits 0 - 9
2 = Alphanumeric: Digits 0 – 9, uppercase letters A – Z, special characters $%*+-./:
3 = Binary: all 256 ASCII characters
4 = Kanji characters in two–byte encoding according to the JIS Shift 0208 standard
p parameter: Error correction level
Possible values:
1 = 7 %
2 = 15 %
3 = 25 %
4 = 30 %
If you do not specify the p parameter, then 15 % is used by default.
b parameter: Size of a module in dots relative to 600 dpi
Permissible values: 1 – 1000, where it should be noted that a size of less than 6 is
too small to be recognised by most reading devices and that at very large module
sizes the symbol cannot be printed in full on the page. If you do not specify the b
parameter, then 10 is used by default.
44
To Next Page
Loading...
Need help?
General
Weight and Dimensions
