1.8 Supported Devices
PCL Barcode Flash supports Kyocera Mita printers and multifunction devices. At the
time of publishing (version 3.00, March 2008), the following devices are supported:
FS-1010 FS-1050 FS-1020D FS-1030D FS-1100 FS-1300
FS-1800 FS-1800+ FS-1900 FS-1920 FS-2000D FS-3800
FS-3820N FS-3830N FS-3900DN FS-4000DN FS-6020 FS-6950DN
FS-9100 FS-9120DN FS-9130DN FS-9500DN FS-9520DN FS-9530DN
FS-C5015N FS-C5016N FS-C5025N FS-C5030N FS-8000C FS-C8008N
FS-C8026 FS-C8100
KM-1510 KM-1530 KM-1650 KM-1810 KM-2030 KM-2050
KM-2530 KM-2550 KM-2560 KM-3035 KM-3050 KM-3060
KM-3530 KM-4030 KM-4035 KM-4050 KM-4530 KM-5035
KM-5530 KM-5050 KM-6030 KM-6330 KM-7530 KM-8030
KM-C2520 KM-C3225 KM-C3232 KM-C2525E KM-C3232E KM-C4035E
KM-C2630 KM-C830 KM-C850D
An up-to-date compatibility list is available in the service area of www.kyoceramita.eu
Note
Please note that some KM series multifunction devices have to be fitted with a
printer board first
Note
For some of the older supported devices, it might in certain cases be
necessary to make a firmware update.
Note
PCL Barcode Flash assumes that you have a free CF card slot in your printer
or multifunction device. If this is not possible or desired, where necessary a
solution can be created on request (special solution, not free of charge) on an
EPROM module which is inserted into a slot inside the device. At the same
time, this prevents unauthorised access to the CF card.
14
To Next Page
Loading...
Need help?
General