v parameter: Inversion
1 = Symbol is not printed inverted
2 = Symbol is printed inverted
If you do not specify the v parameter, then 1 is used by default, i.e. not inverted.
Examples:
<Esc>(s4p10h1v12b3s24861TDaten
<Esc>(s12,15h2v24861TDaten
The following example including a print-out:
<Esc>(s4p1v30b3s24861T This is a QR Code symbol.
Syntax in Prescribe
In case you are not familiar with programming in PRESCRIBE, it is recommended
that you read the “P
ROGRAMMING WITH PRESCRIBE IIE” manual.
The command BARC is used. The syntax described in the PRESCRIBE manual for
the command BARC applies in respect of the one-dimensional barcodes that are
supported. As you will be able to determine below, the syntax for two-dimensional
barcodes is somewhat different from this.
There are the following parameters, which apart from the “Barcode type” parameter
are all optional. If they are specified, they must be separated by commas.
Barcode type, identity number for QR Code:
102
Module size
45
To Next Page
Loading...
Need help?
General