2-92 Using the Operation Panel
Service (for maintenance)
The options available in Service are as follows:
• Print Status Page (Printing the service status page)
• Print Network Status Page (Printing the network status page)
• Print Test Page
• Maintenance (New Maintenance Kit replacement confirmation setting)
• DEV-CLN (Developer/Refresh mode setting)
• LSU/Charger (LSU/Main charger cleaning mode setting)
• Drum (Drum/Refresh mode setting)
IMPORTANT Service is primarily a menu used by service personnel
for maintenance work. There is no need for customers to use this
menu.
1 Press Z while Adjust/Maintenance > is displayed.
2 Press U or V repeatedly until >Service > appears.
Print Status Page (Printing the service status page)
The service status page contains printer settings information that is more
detailed than the standard status page and is therefore mostly for service
purposes. However, there is a great deal of information on the service
status page that may be useful to you.
1 Press Z while >Service > is displayed.
2 Press U or V repeatedly until >>Print Status Page appears.
3 Press [OK]. A question mark (?) appears.
4 Press [OK] again. Processing appears and a service status page
is printed out.
5 When printing ends, the display returns to Ready.
Print Network Status Page (Printing the network status page)
The network status page contains detailed information on the network
settings. This is primarily used for maintenance by service personnel, but
it contains information that may also be useful to you.
1 Press Z while >Service > is displayed.
2 Press U or V repeatedly until >>Print Network Status Page
appears.
3 Press [OK]. A question mark (?) appears.
4 Press [OK] again. Processing appears and a network status page
is printed out.
5 When printing ends, the display returns to Ready.
To Next Page
Loading...
Need help?
General