2-8 Using the Operation Panel
Using the Menu Selection System
Menu Selection System
This section explains how to use the menu selection system.
[MENU] on the operation panel allows you to use the menu to configure
the printer settings to your specific needs. Settings can be made when
Ready is indicated on the printer message display.
Entering the Mode Selection Menu
Press [MENU] when Ready is indicated on the printer message display.
The mode selection menu is displayed.
IMPORTANT The Custom Box option appears in the mode selection
menu when the hard disk is installed. The
Job Box option appears
when the hard disk is installed or the RAM disk has been set up.
For more information, please refer to Custom Box (Using a Custom
Box) on page 2-19, Job Box on page 2-23 or RAM Disk Mode (Using
the RAM disk) on page 2-56.
Note Settings that are received from application software and
the printer driver will take priority over settings made in the
operation panel.
To Next Page
Loading...
Need help?
General