11
Product Service: Domestic 1-800-522-7658, International 816-333-8811
Chapter 2: Prerequisites
Vacuum pumps used with 115V models should be
equipped with a 115V, 15 Amp NEMA 5-15P plug.
Vacuum pumps used with 230V models should be
equipped with a 250V, 15 Amp NEMA 6-15P plug (a
250V, 15 Amp NEMA 6-15P plug is included with
230V models). This will allow the vacuum pump to be
plugged into the receptacle on the junction box inside
the console cabinet. See Appendix D: Freeze Dryer
Accessories for vacuum pumps available from
Labconco.
Chamber or Manifold
Requirements
A freeze drying chamber or manifold is not included
and must be purchased separately. These allow
samples to be attached to the Freeze Dryer. See
Appendix D: Freeze Dryer Accessories for available
chambers and manifolds.
Space Requirements
Refer to Appendix C: Freeze Dryer Specifications for
dimensional drawings of the Freeze Dryer.
Your Next Step
After you have determined that the location for your
Freeze Dryer accommodates the installation and
operational requirements, you are ready to unpack and
install your Freeze Dryer. Proceed to Chapter 3:
Getting Started.
To Next Page
Loading...
Need help?
General
