9
90024140rev00
OPERATIONS
5.1
•
SWITCH ON
Press key 1. If a symbol appears in the
fault warning display, refer to “Self-
diagnosis and fault identification”. Page 19.
Note: Cooking in manual mode with a
number of phases in sequence permits
preheating the cavity with no load before
putting food into the oven: it will be
enough to set the time for cycle 1 on
infinite “[ Inf ]“ and, on reaching the
preheating temperature, a cyclical beep
will indicate it is time to put the food into
the oven. On closing the door, display 9
will show “2” indicating cooking cycle 2
has started.
5.2
•
SET THE TEMPERATURE OF
CYCLE 1
Turning knob 25 sets the cooking
temperature, which is shown on the
relevant display.
5.3 • SET THE TIME OF CYCLE 1
The time display shows [ 000 ].
Turn knob 26:
to the right to set the cooking
time; to the left to set infinite time, [ Inf ]
thus utilizing the first cycle as preheating.
5.4
•
SELECT CYCLE 2 AND THE
FOLLOWING ONES (UP TO
9 CYCLES)
Press key 19, display 5 will show “MAN”
and display 6 will show “C1”. Turn knob 26
until “C2” appears; press key 19 to confirm
the selection.
Now go back to paragraph 5.2 to continue
with the setting; to confirm the data
entered, press key 19 again.
Repeat the sequence for further phases if
required.
5 • MANUAL SETTINGS FOR COOKING
WITH UP TO 9 CYCLES IN SEQUENCE
A manual setting with more than one cycle
cannot be saved; for cooking you want to
repeat, it is recommended to use the saved
programs (see “Entering and saving a
program”). Page 11.
To Next Page
Loading...
Need help?
General
