20
90024140rev00
15 • SELF-DIAGNOSIS AND FAULT IDENTIFICATION
MESSAGES
“ Err Sc ”
Message on the display 5 and 6. Oven temperature probe
faulty, switch off the oven immediately and contact a
manufacturer technician or authorized service agent.
“ no H2o ”
This means there is no water, so it is necessary to check
that the shutoff valve is open and that there is water still
coming from the main. If there is no supply from the main,
inform the water company or agency. If there is no problem
with the main, contact a manufacturer technician or
authorized service agent. In the meantime, the oven can
still be used in convection mode.
“ Er 1 ”
The device preventing thermal overload of the motor
has cut in. Switch off the oven immediately and contact
a manufacturer technician or authorized service agent.
“ Er 2 ”
The oven safety thermostat has cut in. Switch off the
oven immediately and contact a manufacturer technician
or authorized service agent.
“ Er 7 ”
An abnormally high temperature rise has registered in
the compartment housing electrical components. The
oven can still be used under close observation, until the
arrival of a service technician.
“ Er 8 ”
An excessive temperature rise registering in the electrical
components compartment could result in damage to
components. Switch off the oven immediately and
contact a manufacturer technician or authorized service
agent.
The main fault warning messages are:
To Next Page
Loading...
Need help?
General
