27
CLEANING AND PREVENTIVE
MAINTENANCE
PRECAUTION AND CLEANING
INSTRUCTIONS
- IMPORTANT : Before carrying out the
cleaning and maintenance operations,
disconnect the equipment from the mains
power supply:
- Follow the directions on the maitenance in
this guide;
- Wear protective clothing and gloves when
challenged elements are impregned with
clearing solution;
- High temperatures can be reached inside
the machine (90°C). After power supply has been
removed, wait until the machine has reached
room temperature, before working on it.
- Never leave tools, parts or other loose
material in or on the machine;
- Chek that there are no rusting foreign
bodies, because of the material “stainless steel”
could begin to rust. Rust particles can come from
non- stainless steel dishes or damaged wire
baskets.
- Do not wash the machine and the area
surrounding it with fire hydrants, steam jets of
high-pressure cleaners;
- When clearing the floor be careful not to
saturate the base of the machine, in order to
avoid a prolonged stagnation of water;
- To clean the inside of the machine, use a
brush or a soft cloth;
- To clean the machine do not use abrasive
cleaners;
- BEFORE starting machine or cycle, after
any maintenance or repair work, make sure
all protectives are correctly installed;
DAILY MAINTENANCE
- Disconnect the machine by wall switch
and with pushbutton "A";
Please pay attention to the opening and
closing of the door of the Dish/Glass-washers. Do not
use the machine if you are wearing clothes/items that
could get entangles in the dishwasher parts. As they
can limit personnel’s regular moving ability!
- Lift the overflow pipe and let the water
drain out of the tank;
- Wash thoroughly the tank and the filter
housing to remove all the impurities;
- Take the filters and clean them under
running water;
- Re-assemble the overflow pipe and the
filters in their housings;
- Check and clean the washing and the
rinsing jets;
- Clean the outer surface of the machine by
using a wet sponge; don't use water jets
because, besides being dangerous they
could damage the electrical parts; don't
use abrasive detergents;
- When the machine is to remain idle for a
long time, drain all the water from the
boiler and from the electropump.
Also leave the wash tank open.
Attention. Before carrying out cleaning
the inside of the machine, make sure that there
are no foreign objects that could damage the
rusty steel inside the tank. The eventual rust
particles could come from non-stainless steel
dishes, from baskets or damaged water pipes
not rust-proof.
NEVER WASH THE EXTERNAL PART OF
THE MACHINE WITH A WATER JET
To Next Page
Loading...
Need help?
General
