pag. 5
ENGLISH
4 - ALARM SYSTEM OPERATION
To arm the alarm, press the lock or deadlock** button on the vehicles original remote control; the alarm
may give two acoustic tones* and the direction indicator lights may flash a number of times** to indicate
that the system is now armed.
Once armed, the alarm system will operate the comfort closure**/window closure* if these functions
have been incorporated.
The red LED in the receptacle will remain on for 40 seconds (pre-alarm time), then begin to flash to
indicate the alarm system is fully armed.
To disarm the alarm, press the unlock button on the vehicle original remote control; the alarm may
give one acoustic tone* and the direction indicator lights may flash a number of times** to indicate that
the alarm system is now disarmed.
Ø In some vehicles, when using the mechanical key for the door locking, the alarm system will
arm. It is possible in some cases, when unlocking the vehicle by the mechanical key, during
the pre-alarm time of arming, the alarm system will disarm.For security reasons when the
alarm is fully armed the system can only be disarmed by remote control or by the electronic
key.
Ø Comfort closure is a feature that may already be incorporated into the original remote control
of the vehicle. Check vehicle user guide for operation.
Ø If the alarm as been triggered by manually opening a door it may be necessary to close the
door, then lock and unlock with the original remote control to disarm the alarm.
4.2 - ALARM CONDITION
When fully armed if a sensor is activated, the system will generate an alarm condition: direction
indicators may flash and the siren will sound for 27 seconds (alarm cycle). At the end of the alarm cycle,
if the same sensor is still activated, the alarm will generate an alarm cycle again.
4.1 - ALARM SYSTEM ARMING/DISARMIG
ISUT670T NEW.p6519/12/2011, 16.065
To Next Page
Loading...
Need help?
General
