Lauterbach MMDSP User Manual

MMDSP Debugger 2 4
©1989-2019 Lauterbach GmbH
SYStem.Option EnReset Control activation of the reset line
Default: OFF.
The command controls whether the debugger will (ever) pull the reset line. As the MMDSP is normally used
as "slave" in multi-core systems, the default setting for the option is OFF. Consequently the reset line will
never be activated on default.
Additionally you might want to use the option "SYStem.CONFIG SLAVE ON" in order to also disable the
reset of the TAP controller when connecting to the target.
SYStem.Option IMASKASM Disable interrupts while single stepping
Default: OFF.
If enabled, all interrupts will be masked during assembler single-step operations by use of the
EMU_UNIT_MASKIT register (MMIO @ 0xF600). After the single step the register is restored to the original
value. If the option is disabled, the EMU_UNIT_MASKIT register is not modified.
SYStem.Option IMASKHLL Disable interrupts while HLL single stepping
Default: OFF.
If enabled, all interrupts will be masked during HLL single-step operations by use of the
EMU_UNIT_MASKIT register (MMIO @ 0xF600). After the single step the register is restored to the original
value. If the option is disabled, the EMU_UNIT_MASKIT register is not modified.
Format: SYStem.Option EnReset [ON | OFF]
Format: SYStem.Option IMASKASM [ON | OFF]
Format: SYStem.Option IMASKHLL [ON | OFF]

Lauterbach MMDSP Specifications

General

Brand	Lauterbach
Model	MMDSP
Category	Computer Accessories
Language	English