Name: Lauterbach MMDSP
Brand: Lauterbach
Rating: 4 (1 reviews)

To Next Page

To Previous Page

MMDSP Debugger 4

Warning

NOTE: To prevent debugger and target from damage it is recommended to

connect or disconnect the debug cable only while the target power is

OFF.

Recommendation for the software start:

1. Disconnect the debug cable from the target while the target

power is off.

2. Connect the host system, the TRACE32 hardware and the

debug cable.

3. Power ON the TRACE32 hardware.

4. Start the TRACE32 software to load the debugger firmware.

5. Connect the debug cable to the target.

6. Switch the target power ON.

7. Configure your debugger e.g. via a start-up script.

Power down:

1. Switch off the target power.

2. Disconnect the debug cable from the target.

3. Close the TRACE32 software.

4. Power OFF the TRACE32 hardware.

Questions and Answers:

Need help?

Do you have a question about the Lauterbach MMDSP and is the answer not in the manual?

Lauterbach MMDSP Specifications

General