4
GENERAL SAFETY RULES
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR GRASS TRIMMER
• Do not expose to moisture.
• Use only on AC mains supply voltage shown on the product rating label.
• Avoid operating your trimmer in wet grass, where feasible.
• Take care in wet grass, you may lose your footing.
• On slopes, be extra careful of your footing and wear nonslip footwear.
• Do not walk backwards when trimming, you could trip. Walk never run.
• Switch off before pushing the trimmer over surfaces other than grass.
• Never pick up or carry a trimmer by the cord.
• Do not lean over the trimmer guard objects may be throw by the rotating TrimFast blades.
• Keep all nuts, bolts and screws tight to be sure the trimmer is in safe working condition.
• To avoid the risk of injury keep fingers and hands clear of therotating TrimFast blades on the
leading edge of the guard.
MAINTENANCE
• After use, disconnect the grass trimmer. from the power source and check for damage
• When not in use store the grass trimmer. out of the reach of children
• Electrical powered trimmers should only be repaired by an authorised repairer
• Use only manufacturers recommended replacement parts and accessories. The preparation for
use, operation and maintenance of the grass trimmer:
- Read the instructions carefully;
- Be familiar with the controls and proper use of the grass trimmer.
- Before use check the supply and extension cord for signs of damage or ageing,
- If the cord becomes damaged during use, disconnect the cord from the power supply immediately.
DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY;
- Do not use the lawn trimmer (edge trimmer), if the cords are damaged or worn.
W A R N I N G
- Cutting elements continue to rotate after the motor is switched off;
- Keep extension cords away from cutting elements;
- It is recommended that grass trimmers should be supplied via a residual current device (RCD) with
a tripping current of not more than 30mA.
To Next Page
Loading...
Need help?
General
