Lennox DVR5-CMNS User Manual

Acombustible mantel shelf projecting a maxi-
mum of 8° (203 mm) from the wall may be
installed a minimum distance of 18*
(457 mm) from the top of the door frame
(Figure 37 ).
an:
Max. Projection 8 (203 i 40 2" Min,
{1029 mm)
0 Ceiting
From Top of
Cee
jaor
4" Clearance to
Combustible Side Wali*
“Note: For Canadian installations 6” (152mm)
clearance te combustible side wall required.
Figure 31
COLD CLIMATE INSULATION
If you live in a cold climate, seal all cracks
around your appliance with noncombustible
material and wherever cold air could enter the
room. ft fs especially important to insulate
outside chase cavity between studs and under
floor on which appliance rests, if floor is above
ground level.
DIRECT VENT SERIES OPTIONS
An incomparable package of options are avail-
able for use with the Direct Vent Series. These
options can both customize the operation of
these unique appliances and enhance their
beauty and charming appeal. All options are
available in kit form, are easy to install and are
packaged complete with all required parts and
instructions. Some of the option kits need to be
fitted prior to completing the insiallation of the
appliance. The following paragraphs detail the
kit options available for use with the appliances
covered in this manual.
These outstanding optional items can be added
individually or in sets of two or more to custom-
ize your direct vent appliance to fit your homes
unique needs. Kit part numbers are provided
on pages 18 and 19 along with descriptive
illustrations.
Forced Air Kit
The _FAB-1100 blower provides for a constant
velocity forced air circulation feature for your
appliance.
The _FAB-1600 assembly with variable speed
wail switch provides a forced air circulation
feature for your appliance.
These kits mount directly into the lower intake
chamber with an electrical connection made at
the receptacle provided. The appliance must
have an independent 120Vac power line incor-
porated at the time of installation. Refer to Step
6 of the installation instructions supplied with
the forced air kit (Figures 32 and 33).
Figure 32
Blower Motor
Ga
Grounded
to Appliance
Motor Plug
ora
ul
us
f
I
1 Receptacle
i
—t- i
120V
|
1
Appliance Junction Box
Figure 33
Remote Control Kit
The Model _RCK adds the convenience of re-
mote control for your appliance. The kit in-
cludes a wireless, hand held transmitter and a
receiver that replaces the wall switch. This
special receiver permits either manual or re-
mote control modes. Both receiver and trans-
mitter operate on standard 9 volt batteries (not
included). Refer to the RCK installation in-
struction for specific details.
Decorative Log Rack
The decorative log rack provides the look of a
wrought iron log grate. The log rack is easy to
install. Simply place the log rackin front of the
gas logs. This kit can be retrofitted to previously
installed appliances.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Wall Switch Kit
An optional wall switch kit can be installed
along with ail _DVR5 Series appliances. The
kit consists of a standard UL wall switch with
cover plate. This kit provides for remote (wall)
operation of the appliance. Replace the wall
switch and cover plate of this kit with the
components of the _RCK and you can have
true remote control of your direct vent appli-
ance, turning it on and off from your favorite
easy chair. The wall switch kit should be in-
stalled along with the appliance. Refer to Fig-
ures 15 and 17 and Steps 6 and 7 for detailed
installation instructions.
Optional on Unit Rocker Switch
An optional rocker switch kit can be installed
directly on all_DVR5 Series appliances to pro-
vide for On and Off operation in lieu of a wall
switch. This kit is designed to install in the
Jower control compartment out of view and is
perfect for use in high volume areas such as
lobbies and model homes where limited access
to the appliance On/Off switch is desirable. This
kit can be retrofitted to previously installed
appliances and may be temporarily installed in
place of other switch circuitry.
Decorative Volcanic Stone
The decorative volcanic stone, Model _DVS,
can be used to enhance the took of your appli-
ance. Spread the decorative volcanic stone
evenly around the bottom of the firebox.
Refractory Liner Kit
One of the most beautiful enhancements you
can make tothe _DVR5 Series is the addition of
refractory liners. The refractory liner kit in-
cludes tan ceramic fiber panels for the rear and
side walls of the firebox. The ceramic fiber
panels have brick-like features in relief. To
install the six panels, simply place them in
position against the firebox wails. This kit can
be retrofitted into previously installed appli-
ances.
Square Trim Kit
Asquare trim kitis available for the Direct Vent
Series. This kit is easy to install and does not
Fequire hardware to attach it as designed,
directly to the standard door frame. The four
plece square trim kit-can be installed without
the bottom or bottom and side pieces to cus-
tomize the look of our appliance. This kit can
be retrofitted to previously installed appli-
ances.
13
f i r e - p a r t s . c o m

Lennox DVR5-CMNS Specifications

General

Brand	Lennox
Model	DVR5-CMNS
Category	Fireplace Accessories
Language	English