2-6 C27-30 Flat Panel Monitor User’s Guide
Adjusting your monitor image
This section describes the user control features used to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Note: The direct access controls are coloured.
Table 2-1. Direct access controls
Icon Control Description
Input change Switches the video input source.
Image Setup Activates automatic image adjustment.
Brightness Direct access to Brightness adjustment.
Main menu Open OSD main menu
Low Blue Light
Press and hold for 3 seconds to enable/disable
Low Blue Light.
Using the On-Screen Display (OSD) controls
The settings adjustable with the user controls are viewed through the On-Screen Display
(OSD), as shown below.
To use the controls:
1. Press to open the main OSD menu.
2. Use to access that
function. If there is a sub-menu, you can move between options using
or to move among the icons. Select an icon and press
, then press
to select that function. Use
or
or to make adjustments. Press to save.
3. Press to move backwards through the sub-menus and exit from the OSD.
4. When un-OSD, press and hold for 10 seconds to lock the OSD. This will prevent
accidental adjustments to the OSD. When un-OSD, press and hold for 10 seconds to
unlock the OSD and allow adjustments to the OSD.
5. Enables DDC/CI by default. Use OSD Exit Key, press and hold the buttons for 10
seconds to disable/enable DDC/CI function. The words " DDC/CI
Disable/DDC/CI/Enable" shows on the screen.