Lenze E82ZBB User Manual

6
Operation
Remote parameterisation of system bus devices
EDK82ZBC DE/EN/FR 3.1
66

Parameter ändern u speichern----(DUMMYSEITEVOR)---
Remote parameterisation of system bus devices If controllers are networked via systembus (CAN), you can set the parametersof all system bus nodes remotelyfrom a central place of the network. For this, use the  function.
 Note!
The system bus node can also be selected via C0370 instead of using the  function.
Step
Key sequence
Result Action
1.
Select function

o Change to function bar 2
2.
 
3.
Select address of the node

1 ... 63 Select node address
4.

n 
Confirm address and change to function bar 1 The node can be parameterised remotely.
5. Set parameters All settings are redirected to the node selected. 6. If required, further
system bus nodes can be parameterised remotely
Restart ”loop” with step 1.
Do not forget to switch off the remote parameterisation after completing the settings: 7.
Switch off remote parameterisation

o Change to function bar 2
8.
 
9.

0 Switch off remote parameterisation
10.

n Confirm and change to function bar 1
The remote parameterisation is completed.

Lenze E82ZBB Specifications

General

Brand	Lenze
Model	E82ZBB
Category	Keypad
Language	English